E-Tech ET8 Manuel d'utilisateur télécharger pdf (Page 9)

E-TECH ET8 V4 CONTROL PANEL - USER MANUAL

OPERATION

The control panel must be Armed prior to

vacating the premises in order to detect

intruders. Ensure that the panel is not in

Program, Memory or Exclude modes.

Note: If the panel is already in alarm, you must first

silence the alarm before you can Arm.

If something is wrong when Arming the control

panel, the normal 3 beeps will be replaced by

other warnings.

10 beeps means Mains Power is

turned off or the Backup Battery is low.

One long beep indicates an invalid

entry or an alarm is outstanding and needs to

be reset by entering your User Code first.

SIREN WARNING:

At the end of the exit time, all zones should be

Sealed. If any are Unsealed, the siren will sound

for 2 seconds as a warning to indicate that those

zones have been automatically excluded. For

maximum security, you should return, Disarm,

check the premises and then Arm again.

Continual warnings could mean that a detector

is faulty and may have to be manually excluded.

If the auto-exclude option is disabled, the siren

will sound for the duration of reset time if a zone

is Unsealed at the end of exit time.

or...

[User Code]

ARM

ENTER

or...

The light must be offNot ReadyThe light must be onReady

Press...Press...

The Armed light will turn on

• Leave the premises within the Exit Delay Time

• 3 beeps will sound at the end of Exit Delay Time

The icon will turn on

• Leave the premises within the Exit Delay Time

• 3 beeps will sound at the end of Exit Delay Time

[User Code]

LED KEYPAD

ARMING

LCD KEYPAD

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

E-Tech ET8 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité E-Tech ET8