E-Tech ET8 Manuel d'installation télécharger pdf (Page 58)

E-TECH ET8 (V4) CONTROL PANEL – INSTALLER MANUAL

AUDIBLE MONITORING

While Central Station Monitoring is recommended, the ET8 can also send

audible alarm reports to any DTMF capable telephone. The types of alarms

sent are listed in the Reporting Format Table.

The basic audible message takes the form of:

N [pause] A [pause] B [pause]

N = The first digit of the Account Number, P72E.

(N can be the digits 1–9. If P72E starts with 0, N is not sent).

A = First digit of the Alarm identifier (See Reporting Format Table).

B = Second digit of the Alarm identifier (See Reporting Format Table).

MESSAGE EXAMPLE (AUDIBLE PULSE FORMAT P86E 4E)

If the Account Number is 1234 and zone 5 alarm is reported:

beep beep beep beep beep beep[pause]

1 Beep

5 Beeps

= 1st digit of the

= zone 5

account number

REPORTING SEQUENCE

When triggered by an alarm event the ET8 will call the Primary Telephone

Number (or the Follow Me Telephone Number, if programmed) and at the end

of the dialling of the last digit, it will wait for 5 seconds and then commence the

audible message, the audible message will continue to repeat for 45 seconds

or until it is kissed off by a DTMF tone.

If there is more than one alarm message to transmit then after it has received

the Kiss-off/ Acknowledge tone it will commence transmission of the next

message. The ET8 should continue to do this until all alarm messages are

transmitted and Kissed-off.

ACKNOWLEDGE TONE

The person receiving the call can then acknowledge the alarm by pressing the

key on their telephone. Press the key for at least 2 seconds during

pauses in the audible message.

If the alarm is not acknowledged, the keypad’s LINE light will flash continuously

until the panel is next Armed.

ALARM EVENTS SENT

The Reporting Format Table identifies the alarm events which can be

programmed to be sent in Audible Format.

Open/Close reports, Restorals and Exclusions (Isolates) are NOT sent in

Audible Format, even if selected ON.

CENTRAL STATION MONITORING

The ET8 control panel has an on-board digital dialler which can send detailed

alarm messages to a Central Monitoring Station.

The digital messages can include information about the zone/s which caused

the alarm, tamper alarms, low battery or mains failure reports, and it can also

(by user number) identify the users who Arm and Disarm the system.

Central Station Monitoring is highly recommended and is the most effective

method of monitoring your ET8 alarm system.

Installers are welcome to contact E-Tech for further information about

monitoring.

MONITORED PREMISES

CENTRAL STATION MONITORING

TELEPHONE LINE MONITORING STATION

AUDIBLE MONITORING

REPORTING FORMAT TABLE

DIGIT

ALARM

Zone 1

Zone 2

Zone 3

Zone 4

Zone 5

Zone 6

Zone 7

Zone 8

Duress

Keyswitch Tamper/Panic

Keypad Panic

Radio Panic

Medical alarm

Fire alarm

Exit from installer program mode

External Tamper

Internal Panel Tamper

Keypad Tamper

Radio Tamper

Mains Fail

Panel Battery Fail

RADIO Battery Fail

RADIO Supervision Fail

MONITORED PREMISES

AUDIBLE MONITORING

TELEPHONE LINE MOBILE TELEPHONE

FIXED TELEPHONE

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 64

Commentaires sur ces manuels

Pas de commentaire

E-Tech ET8 Manuel d'installation Page 58

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité E-Tech ET8